TECHNICAL

F1.P

GENERAL
Durable corrosion resistant construction specifically for outdoor use.

Heat input 12kW (41,000 BTU/h).

Gas type: Liquid Petroleum Gas LPG.

Flame protection by 100% shut off thermo electric valve.

Ignition of pilot by piezo igniter.

Bottle cover houses up to 13kg LPG cylinder.

The unit incorporates a hollow base which must be filled with ballast before use (not supplied).

Standard overall height: 2,260 mm

Width at widest point: 860 mm

LOCATION & COVERAGE
A single heater will provide warmth with a diameter of up to 6 metres, depending on weather conditions. Maintaining a comfort level in a sheltered area is easier than in an exposed area. If possible locate heaters in places sheltered from winds, near buildings, walls, fences etc.

Groups of heaters can be used to heat large areas, positioning them to give overlapping heat patterns. This gives an all round radiant warmth for even greater comfort.

LOCATION HEATER SPACING
Well shielded areas, mild climate Up to 6m
Shielded 2 sides, average climate 4.25m
Little shielding, cool climate 3m
Exposed, cold climate 2.5m

ACCESSORIES & OPTIONS
Circular Table Top. Fits around pole above bottle cover.

Telescopic Pole. Lowers down into bottle cover for easy of storage and /or transportation.

Clamp Down Lugs. Used to screw heater down to the floor for security in exposed locations.

Wheel Attachment. Permanently fixed wheels for easy movement of portable heaters.

Burner Cover Bag. For winter protection.

Tip Over Protection. Cuts off gas supply to burner if heater is tipped over.

Sack Trolley. To assist in transportation.

Factory Pre-assembly. Pre-assembly option (excludes ballast).

Special Colour Options. Corporate colour schemes and logos for special bulk order.

Alternative Heights. Extra high & lower height heaters can be supplied to special order.

Extended Guarantee. Available

IMPORTANT – SAFETY
Combustible Materials. Heaters must be located such that the indicated safety clearance distances from combustible materials are ensured.

Storage and handling of gas bottles must be carried out in accordance with local codes of practice. After connecting the gas supply to a heater, always check for gas leaks using a soap solution.

Refer to the manufacturer’s Assembly and Use Instructions for further information.

Designed for outdoor use only, with adequate high and low level ventilation.

SAFETY CLEARANCE DISTANCES

ENQUIRIES

Fill in your details below and we will be in touch

Fill out this field
Please enter a valid email address.
Fill out this field

To send a more detailed enquiry please click here

Menu